Low-Pressure Steam Jet Liquefier

Please note that when used:

Steam ejector imports, imports of liquid non-return valve to be mounted vertically.
Steam ejector room, feed room be equipped with pressure gauge 0 ~ 1Mpa. Thermometer installed in the interface 0 ~ 105 c electronic thermometer.
In order to avoid packet injector nozzle has been brought to justice, miscellaneous items, such as congestion, should be transferred into the slurry tank deslagging basket when the retro-fitting (14 mesh head 16 head / inch).
Starch milk feed pump pressure using the high-temperature concentrated than 0.6Mpa pump.
The device applies to the concentration of 30 ~ 40% of the starch milk. Process demanded by a good pH value, by adding the enzyme preparation required.
Prior to the use of ejector, first of all, the needle valve jet plasma increase 2 to 5 laps, and then open the steam valve. The jet and the high temperature to maintain the tank preheat to 108 degrees, and then start the feed pump, open the feed valve, and gradually return valve clearance small, so that access to the liquid jet into the jet is greater than the pressure of the vapor pressure, adjusted valve, needle valve of the flow of milk so that the formation of starch from the nozzle into the hollow membrane technology pipeline.
Steam conditioning valves and feed valves, so that the export of liquefied process temperature requirements.
After the application of liquefied spray rinse, and maintain its cleanliness.
Low-pressure steam-jet structure and installation of liquefied diagram